Ikco Pickup Owner's Manual page 43

SWITCHING ON AND DRIVING WHILE USING CNG
3
A) Operating on CNG mode before
starting
Start the engine then put the fuel
conversion key on gas. In this mode, in
addition to the light on the right side of the
conversion key (yellow) being turned on,
the green light on the left and the red light
for saving gas on the left of the conversion
key are blipping fast.
The blinking of the lights on the conversion
switches show that fuel consumption
has not turned yet from gasoline to gas.
Therefore the fuel conversion is done and
lights are frequently on and gas saving red
lights and yellow ones on the right side are
turned off. When the engine is turned on,
42
the 4 green lights of the conversion key
are turned on in compliance with the gas
pressure inside the gas pump.
B) Selecting CNG fuel while moving
Put the fuel conversion key on gas mode
(on the left) and the fuel converted to gas
instantly.
C) Turning the engine on CNG
mode directly
This method is used only for special
situations like gasoline shortage and
it's not recommended at the ordinary
conditions. Fist turn on the switch and
put the fuel conversion key on the gas
mode. Then start the engine. If there is no
technical malfunction in the gas system,
the engine will start on CNG.
D) Fuel conversion from gas to gasoline
Switching to gasoline is easily done in any
case just by pushing the fuel conversion
key on the gas mode. When the engine
is started on the gasoline mode, the right
light of the conversion key (yellow) is on.