Ikco Pickup Owner's Manual page 56

Running-in of engine and gearbox
The running-in of a new engine, gearbox
and differential are very important, which
should be taken under care of driver,
because only under this circumstances
can be ensured that different components
of vehicle will worked for long period
of time, with minimum cost and most
efficiency. It should be noted that the
running-in process should be applied not
only for engine and gearbox, but also it has
special importance for other components
of chassis such as wheel ball bearings and
other moving parts of a car.
This process should be carried out carefully
and gradually for the first 3000 km driving.
It should be considered that within running-in
period, the engine must not be overloaded.
In cases such as uphill driving with fourth
gear in low speed, lower gears should be
selected. Caring new car in the period of
running-in, either in driving or engine idling,
is significantly important.
In first 800Km of driving, the maximum
speed must be kept in following limits:
First gear 15 Km/h
Second gear 30 Km/h
Third gear 50 Km/h
Fourth gear 65 Km/h
Fifth gear 80 Km/h
Between first 800 to 1600 Km of driving,
the car speed must not be exceeded from
the following values and after this duration
the speed may be increased gradually:
First gear 20 Km/h
Second gear 40 Km/h
Third gear 60 Km/h
Fourth gear 90 km
After completion of first 800Km, the car
must be brought to an IRANKHODRO
authorized service center for free service
and checking
MAINTENANCE
Caution
Should the vehicle is going not to be
used for more than 6 days, it should
be started at least once and work one
hour idle.
4
55