Identify Usual Trouble Of Washer - Midea MFW-V1100DDi Owner's Manual

Identify usual trouble of washer

If the washer can not work normally, or appear abnormal or alarms, please check and
correct as follows.
List of faults and inspection
Faults
! If the power is off or the fuse is burned out.
! If the water supply is cut off or the water pressure is too low.
! If the inlet hose is properly connected and the water tap is opened.
! If the filtering screen of inlet valve is blocked by dirt.
No water
! If the coil of inlet valve is damaged. (The slight electromagnetic
flows in
sound is normal phenomenon when the inlet valve is switched on)
! If the "Start / Pause" button is pressed after the power
switch is pressed.
! If the power is off or the fuse is burned out.
! If the power supply voltage is too low.
! If the water amount reaches to the required water level.
No
(The washer will not work if the water amount does not reach the
washing
required water level)
! If it is set to "Delay" washing mode. (It will only start to work
until the reservation time reached)
! If the water drain hose is placed very high.
Abnormal
! If the end of water drain hose is sealed in pond.
draining
! If the internal rubber ring of drain valve is blocked by dirt.
! If the door lid is closed.
! If all clothing piled largely at one side of barrel or the clothing
Abnormal is excessively placed.
spin ! If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
! If the motor belt is loosened.
Note: During the de spin process, if washing are piled at one side of the spin barrel,
it will cause unbalance of spin barrel resulting in striking. At this moment, the
computer inside the washer will feel this unbalance phenomenon and will automatically
correct it ( fill in water Washing ). However, if unbalance situation is not removed after
continuous three corrections, which means the computer auto-correction can not
resolve the problem. Then the user has to manually and evenly place the clothing
inside the barrel to solve the problem.
Inspection Items
17
Malfunction display and solutions
When the washer couldn't work well, being abnormal or in alarm, please check and correct
it as follows.
Display Causes
E1
Alarm for abnormal water intaking.
E2
Alarm for water drain has not finished.
E3
Alarm for lid not closed before spin.
E4
Alarm for washing stay at one side.
Children-Lock Alarm if the cover lid open.
Any other abnormal.
F1-F8
Any other abnormal.
The light of adding
Alarm if the detergent is not enough. Add liquid detergent.
detergent is on
Technical specifications
Rated power supply
Input power of motor
Rated washing capacity
Rated spin capacity
Overall dimensions
Application water pressure
Weight of whole machine
Washing mode
Draining mode
Spin mode
Solutions
Check the water tap is opened or not.
Check the water level sensor and
drain pump.
Closed the lid.
Manually balance clothes in the barrel
by hands.
Power off 5 seconds and Restart.
1.power off 5 seconds and Restart. 2.submit repair.
1.power off 5 seconds and Restart. 2.submit repair.
220-240V~50HZ
390W
10.0kg
10.0kg
580 X 640 X 990
0.03MPa~0.8MPa
42kg
New water flow
Gravity drain
Centrifugal spin
18