Quick Start - Midea MFW-V1100DDi Owner's Manual

Quick start

1 Install the washing
machine
2 Load the laundry
3 measure out the
detergent
4 Close the
machine door
5 Put down (hang up)
the drain pipe
Programme selection
1
Press the POWER button.
2 Select the proper water level or other attached functions.
3 To press the start/pause key.
The wash stops
When the wash stops, the buzzer will buzz continuously for 6 times and
then the power will be automatically cut off.
Turn off the water tap.
Although the power can be cut off automatically, the power plug must be pull
out as well for the safety.
9 Press the
[start/pause] key
8 Select the desired
programme
7 Plug the power supply
6 Turn on the water tap
11
The main wash
Normal program
Normal program is the easiest, most convenient and most common washing
program.
1.Press the power button .
2. Press the Program button to select
3.Press the Start/Pause button.
The Operation of Washing process
Users can freely set up wash ,rinse and spin's separate process or Process combination
according to own need. The specific operation as below:
The operation of one touch spin
1.Press the Power button.
2.Press the spin button to choose the spin time.
3.Press the start/pause button.
Washing machine will operate the single spin process.
The operation of single wash
1.Press the Power button.
2.First Press the spin button to make the spin parameter to return to zero, Then Press
wash button to choose the wash tine.
3.Press the start/pause button.
Washing machine will operate the single wash process.
The operation of 'wash and rinse'
1.Press the Power button.
2.First Press the spin button to make the spin parameter to return to zero. Then Press
rinse button, wash button to choose the required parameter.
3.Press the start/pause button.
Washing machine will operate the 'wash and rinse' process. Any other process
combinations are similar with the above
！
! Close the lid when machine is running, otherwise, it will automatically
stop working during spin process and send out abnormal warning.
!The washer will not work when the filled water does not reach the set water level.
! The selection of rinse water level: the level is equal to wash water level.
Press [Rinse Level] button, the indicator light which stand for rinse level flickered.
User can select the rinse water level according to needs. Rinse level exceed that
wash level all the time. It shows the wash level if not press this button. And only
show rinse level when rinse.
! After pressing down [ Power Switch ], if the [Start / Pause ] button is not pressed,
the power will be automatically cut off after 10 minutes.
Normal program .
NOTICE
12