Lexmark MX710 series User Manual page 275

Troubleshooting
Maintenance kit nearly low [80.xy]
For more information, visit the Lexmark support Web site at
support, and then report the message.
If necessary, touch Continue to clear the message and continue printing.
Maintenance kit very low, [x] estimated pages remain [80.xy]
You may need to replace the maintenance kit very soon. For more information, visit the Lexmark support
Web site at http://support.lexmark.com
If necessary, touch Continue to clear the message and continue printing.
Memory full [38]
Try one or more of the following:
•
From the printer control panel, touch Cancel job to clear the message.
•
Install additional printer memory.
Memory full, cannot print faxes
From the control panel, do either of the following:
•
Touch Continue holding faxes without printing to clear the message.
•
Touch Attempt to print to restart the printer and continue printing.
Misfeed cleared, extra sheets in output bin [24y.xx]
Select Continue on the printer control panel to clear the message and continue printing.
Note: To reduce misfeeds, make sure that media is fanned and loaded properly.
Network [x] software error [54]
Try one or more of the following:
•
From the printer control panel, touch Continue to continue printing.
•
Turn off the printer, wait for about 10 seconds, and then turn the printer back on.
•
Update the network firmware in the printer or print server. For more information, visit the Lexmark
support Web site at http://support.lexmark.com.
No analog phone line connected to modem, fax is disabled.
Connect the printer to an analog phone line.
Non‑Lexmark [supply type], see User's Guide [33.xy]
Note: The supply type can be toner cartridge or imaging unit.
http://support.lexmark.com
or contact customer support, and then report the message.
275
or contact customer