Siemens SINUMERIK 840D sl Manual page 31

Pin
8
9
10
11
12
13
14
15
Status LEDs
Table 4-15
DIP switch S1
Setting the handwheel signal type
- S1 open: TTL
- S1 closed: Differential interface
Switch S2
Table 4-16 Switch S2 setting as delivered
1 2 3 4
off off off off
The two switches S2-9 and S2-10 must remain OFF.
The switches S2-1 to S2-8 define the MCP address in the range of 0 to 255.
The addresses from 192 to 223 count as the default range.
The MCP address is used as a reference for addressing an MCP during PLC parameter
assignment.
Table 4-17 Settings of switch S2
1 2 3 4
on on on on
x x x x
ERGOline Stage 3
Manual, 02/2015, 6FC5397-4FP40-0BA0
Name
N.C.-
P5HW
N.C.
M
N.C.
N.C.
N.C.
N.C.
Meaning of the status LEDs
No. Color
H1 Green
H2 Green
H3 Red
5 6 7 8
off off on on
5 6 7 8
on on on on
x x x x
Type Meaning
- Not assigned
V 5V power supply
- Not assigned
V Ground
- Not assigned
- Not assigned
- Not assigned
- Not assigned
Meaning
Power OK
PROFINET LED (BUS SYNC)
PROFINET LED (BUS FAULT)
9 10 Meaning
off off
MCP address 192
9 10 Meaning
off off
MCP address 255
"
Interfaces
4.3 Machine control panels
31