Image EBRTL39515.0 User Manual page 13

11. Insert the wires into the Right Handrail (64)
through the indicated hole as you set the con-
sole assembly on the Left and Right Uprights
(66, 76). Make sure that no wires are pinched.
Attach the console assembly with ten #8 x 3/4"
Screws (4); start all ten Screws, and then
tighten them. Do not overtighten the Screws.
See step 5. Firmly tighten the six 3/8" x 3 1/4"
Screws (2).
12. Orient the Storage Latch Assembly (68) so
that the knob is on the indicated side. Attach
the Storage Latch Assembly to the Left Upright
(66) with two #10 x 3/4" Screws (8); start both
Screws, and then tighten them.
13. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see page 22). Note: Extra hardware may be
included.
11
Wires
Hole
4
64
4
76
12
Knob
8
13
Console Assembly
Wires
4
4
66
68
66
4