Pentair BLUEFURY Installation Manual page 15

TROUBLESHOOTING
Problem
Brush on front of cleaner is not spinning.
Rear wheels dragging/not spinning.
Rear wheels falling off.
Night Cruize™ LEDs are not illuminated
during cleaner operation. (Note: LED
operation does not affect cleaner
performance.)
371674 (REV 02/2014)
(Continued)
Corrective Action
Watch front wheels while cleaner is operating in the pool. The wheels and front
brush should rotate simultaneously.
Ensure the scrubber is free of tangled debris.
Ensure the wheel sleeve is free of tangled debris.
Note: You may need to remove the wheel by pulling straight off sleeve to
remove any tangled debris.
Replace wheel and wheel sleeve.
Debris may be clogging generator turbine. To clean debris from generator turbine:
Find access hole under the left rear wheel by removing the wheel by pulling it
straight off cleaner. Use a large paper clip and insert approximately 5cm (2in.)
straight into the access hole, continue until the generator turbine paddle is felt and
move paper clip until paddle rotates. Rotate the paddle several times with paper
clip to clear the debris.
Insert paper clip in
access hole.
15