Booster Pump Installation - Pentair BLUEFURY Installation Manual

INSTALLATION

Booster Pump Installation

Please refer to the instructions included with your
booster pump for installation information.
Please follow these instructions carefully.
Installing the Wall Fitting and Wall Adapter
1. Remove and disconnect any existing pool cleaner
and/or wall fitting.
2. Switch on the filtration pump and booster pump, to
flush out the plumbing line.
3. Switch off filter pump and booster pump.
4. Insert wall fitting adapter into the dedicated 1-1/2"
NPT threaded return line. Hand tighten until snug.
See figure 3.
5. Align wall fitting with the quick lock pegs inside the
wall adapter. Push the wall fitting into the wall adapter
until it bottoms out. Twist 1/4 turn clockwise to lock
the wall fitting. Pull gently outward to engage quick
lock pegs. See figure 3.
Setting the Water Flow to the Cleaner
IMPORTANT!
Before starting this procedure
be sure to switch off the filter pump and
booster pump.
1. Attach the flow gauge to the wall fitting by aligning the two
tabs on the flow gauge with the grooves in the wall fitting.
See figure 4. Push and turn the flow gauge clockwise until
it stops, then slightly pull it out away from the wall. Be
sure the flow gauge is securely locked in place by turning
it counterclockwise while slightly pulling out on the flow
gauge. See figure 5.
Note: Flow gauge will not turn when locked in place.
2. Switch on the filter pump and then the booster pump.
3. Verify the white plunger (inside the flow gauge) is aligned
within the box on the flow gauge. See figure 6.
4. Adjust the valve on the wall fitting using a flathead screw
driver by turning the valve clockwise (to reduce flow) or
counter-clockwise (to increase flow) so that the white
plunger aligns with the arrows on the flow gauge markings.
See figure 7.
5. Switch off the booster pump and then the filter pump.
6. Remove the flow gauge from the wall fitting by pushing in
and turning counterclockwise and pulling the gauge out.
7. Attach the hose assembly to the wall fitting. Turn clockwise
then push in one quarter turn to secure in place (as
described in Step 2).
371674 (REV 02/2014)
Quick
Lock Peg
O-Ring
Installing the Wall Fitting
Figure 3.
Align Tabs
Figure 4.
Wall Fitting
Figure 5.
Max Flow
Min Flow
Figure 6. Figure 7.
Wall Adapter
(Shown Installed)
Wall Fitting
Wall Fitting
Flow Gauge
Turn counterclockwise
to OPEN
5