Yamaha SR-PGB54P Owner's Manual page 64

Advanced sound configurations
y
• Repeat steps 3 and 4 as necessary to change other sound field
program parameter settings.
• The available parameters for some of the sound field programs
may be displayed on more than one page in the OSD. In this
case, press 8 k / n to scroll through pages.
• When you set a sound field parameter to a value other than the
initial factory settings, an asterisk mark (*) appears by the
parameter name in the OSD.
• If you press and hold 8 l / h to change the value, the value
shown in the front panel display will momentarily stop at the
initial factory setting.
• To initialize the parameters of the selected sound field program,
press 8 k / n repeatedly to select "INITIALIZE" and then
press 8 h. In the confirmation screen, press 8 h to confirm
or 8 l to cancel the initialization.
MOVIE
SB INIT.DLY;;15ms
SB ROOM SIZE ;;1.0
DIALOG LIFT;;;;;0
.
INITIALIZE
[[]: Initialize
Press J PARAMETER to turn off the sound
5
field parameter display.
■ Basic configuration of sound field
programs
Each sound field program has some parameters defining
the characteristics of the program. To customize the
selected sound field program, adjust "DSP LEVEL" and/
or "DIALOG LIFT" first, and then try other parameters.
y
To change sound field parameter settings, see page 59 for
details.
Adjusting the effect sound level of the sound
field programs (DSP LEVEL)
Sound field programs add effect sounds (DSP effect
sounds) to the original source sound to create sound field
in the listening room. Use the "DSP LEVEL" parameter to
adjust the level of the effect sounds.
The DSP effect
sound level is low
60
En
2/2
Sci-Fi
The DSP effect sound
level is high
Adjust "DSP LEVEL" as follows:
Increase the value of "DSP LEVEL" when
• the effect sound of the selected sound field
program is too weak.
• you cannot recognize any difference between the
sound field programs.
Decrease the value of "DSP LEVEL" when
• the sound is vague.
• you feel that the additional sound effect is
excessive.
Control range: –6 dB to +3 dB
Adjusting the vertical dialogue position
(DIALOG LIFT)
Use this feature to adjust the vertical position of the
dialogues in movies. The ideal position of the dialogues is
at the center of the video monitor screen.
If the dialogues are heard at the lower position of the video
monitor screen, increase the value of "DIALOG LIFT".
Move up to the ideal dialogue position
Choices: 0, 1, 2, 3, 4, 5
"0" (initial setting) is the lowest position, and "5" is the
highest position.
Notes
• "DIALOG LIFT" is available only when "PRESENCE SP" is
set to "YES" (page 68).
• You cannot move the dialogue position down from the initial
dialogue position.
The ideal
dialogue
position