Table of Contents
Advertisement
Problem
An audio source
The audio source component is not
cannot be recorded by
connected to the DIGITAL INPUT jacks.
the digital recording
Some components cannot records Dolby
component connected
Digital or DTS sources.
to the DIGITAL
OUTPUT jacks.
You are trying to record an audio source
input at the DOCK terminal by the digital
recording component connected to the
DIGITAL OUTPUT jacks.
An audio source
The audio source component is not
cannot be recorded by
connected to the analog AUDIO IN jacks.
the analog recording
component connected
to the analog AUDIO
OUT (DVR, VCR or MD/
CD-R) jacks.
Recorded materials
The settings made on this unit (such as
sound differently.
tonal quality, volume level and sound field
programs) do not affect recorded material.
A video source cannot
"VIDEO CONV." is set to "ON".
be recorded by the
recording component.
The sound field
"MEMORY GUARD" in "SET MENU"
parameters and some
is set to "ON".
other settings of this
unit cannot be
changed.
This unit does not
The internal microcomputer has been
operate properly.
frozen by an external electric shock (such
as lightning or excessive static electricity)
or by a power supply with low voltage.
"CHECK SP WIRES"
Speaker cables are short-circuited.
appears in the front
panel display.
There is noise
This unit is too close to the digital or high-
interference from
frequency equipment.
digital or radio
frequency equipment.
The picture is
The video source uses scrambled or
disturbed.
encoded signals to prevent dubbing.
This unit suddenly
The internal temperature becomes too
enters the standby
high and the overheat protection circuitry
mode.
has been activated.
Cause
Connect the audio source component to the DIGITAL
INPUT jacks.
Connect the recording component to the analog
AUDIO OUT (DVR, VCR or MD/CD-R) jacks.
Connect the audio source component to the AUDIO
IN jacks.
While "VIDEO CONV." is set to "ON", video signals
are output only at the MONITOR OUT jacks. To
record a video source by the recording component, set
"VIDEO CONV." to "OFF" and make the same type
of video connections between each component (e.g.
VCR IN (S VIDEO) to DVR OUT (S VIDEO).
Set "MEMORY GUARD" to "OFF".
Disconnect the power cable from the AC wall outlet
and then plug it in again after about 30 seconds.
Make sure all speaker cables are connected correctly.
Move this unit further away from such equipment.
Wait about 1 hour for this unit to cool down and then
turn it back on.
Troubleshooting
Remedy
See
page
20
20
20
20, 72
76
—
12
—
—
99
En
Advertisement
Table of Contents
