Table of Contents
Advertisement
Problem
No picture.
The output and input for the picture are
connected to different types of video
jacks.
1080p-resolution analog video signals are
only output at the COMPONENT VIDEO
MONITOR OUT jacks.
480p-, 576p-, 1080i- and 720p-resolution
video signals cannot be output at the S
VIDEO and VIDEO MONITOR OUT
jacks.
This unit outputs the video signals are not
supported on the video monitor connected
to the HDMI OUT jack.
Pure Direct mode is active.
Non-standard video signals are input.
Short message
"SHORT MESSAGE" is set to "OFF".
displays do not
"GRAY BACK" is set to "OFF".
appear on the video
monitor.
"VIDEO CONV." is set to "OFF".
The signals input at the HDMI input jacks
are being output at the HDMI OUT jack.
Video signals in the progressive format or
HDTV video signals are being input.
The sound suddenly
The protection circuitry has been activated
goes off.
because of a short circuit, etc.
The sleep timer has turned off this unit.
Sound is heard from
Incorrect cable connections.
the speaker on one
side only.
The speaker level settings are incorrect.
Only the center
When playing a monaural source with a
speaker outputs
CINEMA DSP program, the source signal
substantial sound.
is directed to the center channel, and the
front and surround speakers output effect
sounds.
No sound is heard
"CENTER SP" in "CONFIG" is set to
from the center
"NONE".
speaker.
No sound is heard
This unit is in the "STRAIGHT" mode.
from the presence
speakers.
You are using a source or program
combination that does not output sound
from all channels.
Cause
Set "VIDEO CONV." to "ON" or connect your source
components in the same way as you connect your
video monitor to this unit.
Connect your video monitor to the COMPONENT
VIDEO MONITOR jacks.
Connect your video monitor to the HDMI OUT or
COMPONENT VIDEO MONITOR OUT jacks.
Select "INITIALIZE" in "VIDEO" to reset the video
parameters.
Set "MONITOR CHECK" to "YES".
Turn off the Pure Direct mode.
Set "MODE" in "PURE DIRECT" to
"AUDIO+VIDEO".
Set "SHORT MESSAGE" to "ON".
Set "GRAY BACK" to "AUTO".
Set "VIDEO CONV." to "ON".
Check that the speaker impedance setting is correct.
Check that the speaker wires are not touching each
other and then turn this unit back on.
Turn on this unit, and play the source again.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust "LEVEL" settings.
Set "CENTER SP" to "SMALL" or "LARGE".
Press O STRAIGHT to turn off the "STRAIGHT"
mode.
Try another sound field program.
Troubleshooting
Remedy
See
page
72
18
—
95
95
45
72
76
75
72
25, 94
—
—
12
68
67
44
34
97
En
Advertisement
Table of Contents
