Installation; Software; Hardware - Siemens PROFIBUS DP-V1 Operating Instructions Manual

Installation

The SmartLinx module is either pre-installed in the Siemens device or shipped separately
for on-site installation. Refer to the operating instructions of your Siemens device for
details on module location and physical installation.

Software

Product
MultiRanger 200 HMI
HydroRanger 200 HMI

Hardware

The SmartLinx PROFIBUS DP-V1 module is compatible with the Siemens devices
MultiRanger 200 HMI and the HydroRanger 200 HMI.
Module
connector
(underside,
34-pin) to
Siemens
device
Mounting
hole
Terminal block
Notes:
• Install the SmartLinx module so that the mounting holes align and the pin
connectors mate correctly.
• Correct cable routing is important for electromagnetic noise suppression. Follow
the routing instructions contained your device operating instructions.
A5E36197302
Mounting
hole
Termination
switch
SmartLinx PROFIBUS DP-V1 – Operating Instructions
Software revision
2.00
2.00
Mounting
hole
Node address Status
switches indicators
Page 5