Huawei eSpace EGW1500E Quick Start Manual page 21

eSpace EGW1500E Enterprise Gateway
Quick Start
Figure 3-9 Adding POTS users
Step 3 Perform configurations according to
Table 3-11 Parameter description (5)
Parameter
Port
Internal No
User Name
Registration
Group
External No
Issue 03 (2011-12-20)
Table
Description
Port number used by the common phone to access the EGW1500E. Value
1 indicates the PHONE1 port on the EGW1500E, value 2 indicates the
PHONE2 port, and the rest can be deducted by analogy.
NOTE
You are advised to use the PHONE1 port becuase it supports the power-off survival
function.
The internal number is used for the calls between intra-office
subscribers.1-30 digit number, which can be user-defined. It cannot
conflict with any service prefixes, emergency numbers, outer-office
numbers, or other intra-office numbers.
A string of 1-64 characters, which can be user-defined. For example, Jack.
Registration group used when a POTS user registers with the IMS or
NGN.
NOTE
If the required registration group does not exist, choose Voice > Sip Server, and
click the SIP Group tab to add it.
External number of the user, which is used for outgoing and incoming
calls. It is provided by the carrier.This parameter is valid after you set the
Registration Group parameter. The external number cannot conflict with
any service prefixes, emergency numbers, outer-office numbers, or other
intra-office numbers.
NOTE
Registration Group bound to External No must correspond to the trunk ID. If the
trunk ID starts with +, you need to change + to 00 when you configure External No.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Product Function Configuration
3-11. Click to save the settings.
18