Table of Contents
Advertisement
eSpace EGW1500E Enterprise Gateway
Quick Start
SIP Server Planning
Table 3-7 Configuration reference
SIPServer Type
The value can be NGN or
IMS, which is determined
by the network carrier.
Configure the Session Initiation Protocol (SIP) server.
Step 1 On the web management page, choose Voice > SIP Server from the navigation tree.
Step 2 Click
Figure 3-6 SIP Server tab page
Step 3 Perform configurations according to the following tables. Click
settings.
Table 3-8 Parameter description (1)
Parameter
Working Mode
Recovery
OptionInterval
Issue 03 (2011-12-20)
Address Type
IP/Domain
.
Description
Master: active server. The server that is added first is the active server.
Slave: standby server.
Whether to enable the failback function. When the active server fails,
resources and services will be automatically switched to the standby
server. If this function is enabled, resources and services will be
automatically switched back to the original active server after the
original active server has been recovered.
Interval for sending the option messages to the active server. The value
ranges from 10 to 900, in seconds. The default value 60 is recommended.
NOTE
The option messages are sent to active server only, and therefore this parameter is
valid only for the active server.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Product Function Configuration
Description
IP address or DNS domain name of the
SIP server. The value is provided by the
network carrier. For example, 191.1.1.1.
to save the
14
Advertisement
Table of Contents
