Appendix; Care; Contact With Liquid; Specifications - Gigaset Maxwell 10 Administration Manual

Appendix

Care

Wipe the device with a damp cloth or an antistatic cloth. Do not use solvents or microfibre cloths.
Never use a dry cloth; this can cause static.
In rare cases, contact with chemical substances can cause changes to the device's exterior. Due to the
wide variety of chemical products available on the market, it was not possible to test all substances.
Impairments in high-gloss finishes can be carefully removed using display polishes for mobile
phones.

Contact with liquid

If the device comes into contact with liquid:
§§1§§
Unplug the power supply.
§§2§§
Allow the liquid to drain from the device.
§§3§§
Dry the device thoroughly.
§§4§§
Place the device in a dry, warm place for at least 72 hours (not in a microwave, oven etc.).
§§5§§
Do not switch on the device again until it is completely dry.
When it has fully dried out, you will normally be able to use it again.

Specifications

LAN
USB 2.0
Bluetooth®
DECT
WLAN Standards
Headset connections
Power supply
Power over Ethernet
Power consumption (standby)
Environmental conditions in operation
Language codecs
Quality of Service (QoS)
VoIP protocols
VoIP security
Internet protocols
Further protocols
!
2 port LAN switch: 10 Mbit, 100 Mbit, 1Gbit
type A, high/full/low host interface
Class 2, IEEE 802.15.1
GAP, CAT-iq1.0, EcoMode+
IEEE 802.11b,g,n
Bluetooth®, EHS, corded, USB, DECT
100–240 V, ~50/60 Hz
PoE, IEEE 802.3af, class 3
4.6 W
±0°C to +40°C, 10% to 93% relative humidity
G.711 μ-law/a-law, G.722
RSVP/DiffServ (RFC2474, RFC2475)
SIP (RFC3261, RFC2543), RTP
SRTP (RFC3711), TLS (RFC2246), SIPS
IPv4 (RFC0791), IPv6(RFC2460)
STUN, ICE, TCP, DHCP
Appendix
41