Home Channel Memory; Lock Feature - Yaesu FT-8800 Reference

HOME Channel Memory

1 Select the desired frequency, while operating in the VFO
mode on the "Main" band. Be sure to set up any desired
CTCSS or DCS tones, as well as any desired repeater offset.
The power level may also be set at this time, if you wish to
store it.
2 Press and hold in the [SET] key for 1/2 second. A memory
number will appear (blinking) on the display.
3 While the memory channel number is blinking, just press the
"Main" [H/M] key. The frequency and other data (if any)
will now be stored in the special HOME channel register.
4 You may repeat this process on the other operating bands.
5 To recall the HOME channel, just press the [H/M] key while
operating either in the VFO or MR mode.

LOCK FEATURE

In order to prevent accidental frequency change, the panel
switches and DIAL knobs may be locked out.
To activate the Lock feature:
1. Tap the [SET] key momentarily to enter the Set mode.
2. Rotate the "Main" band DIAL knob to select Menu #21
(LOCK).
3. Tap the "Main" band DIAL knob momentarily, then rotate
the "Main" band DIAL knob to change the setting to "ON."
4. Tap the [SET] key momentarily to save the new setting and
exit to normal operation.
5. To unlock the panel switches and DIAL knobs, select "OFF"
in step 3 above.
[LOW] [V/M] [HM] [SCN]
8 FT-8800 Reference
[SET]