GE PDW8900 Series Technical Service Manual page 7

Enhancements
The
light
above the selected pad will be O N
to
indicate which ENHANCEMElVThas been selected
DELAY HOURS You can delay the start of a wash cycle for up to 24 hours (depending on model). Press the
DELAY STARTpad to choose the number of hours you want to delay the start
of
the cycle; theti
press
STARTBESET
After closing the door, the machine will count down and automatically start at the correct time.
NOTE To cancei the DELAYSTARTselection before the cycle begins, press the DELAYSTART
pad until the display shows the estimated cycle time for the selected cycle in minutes.
ADDED HEAT When selected, the cycle will run longer with heating element on to improve both wash and dry
(EXTRA HOT WASH) performance.
NOTE: Cannot be seiected with RINSEONLYcycle.
PREWASH For use with heavily soiled and/or dried-on, baked-on soils. This option MUSTbe selected PRlORto
(on some models) starting the cycle. This option adds 15 minutes to the cycle time.
NOTE: Cannot be selected with RINSE ONLYcycle.
HEATED DRY Shuts off the dwina heat option. Dishes will air dw naturally iPDW8900 Series) or
7111
Ill1 fsn
OI~(PI)W!?~~)O;PO PO
19910
Suln!s) ro save enclg,
HEATED DRY Turns the nea: na c cne-I on for fast dlVi11a Tn's n exrend rlie Iota cvc'e :
II
e
1,
15 m nures for
the
ANTI - B ACTERI A L
cycle, 8 minutes for the SPEEDcycle, 15 minutes for the PLASTICSC~CI~,
30
minutes for the CHINA CRYSTALcycle, and
38
minutes for all other cycles.
NOTE: Cannot be selected with RINSE ONLYcvcle.
LOCK You can lock the controls to prevent any selections from being made. Or you can lock the controls
fi after you have started a cycle.
Children cannot accidentally
start
dishwasher by touching pads with this option selected.
To unlock the dishwasher controls, press and hold h e HEATED DRYpad for
3
seconds. To lock the
dishwasher, press and hold the HEATED DRYpad for 3 seconds. The light above the LDCKpad
--.
will turn off.
RESIT To change a cycle after washing starts.. .
PDW%100 Series: Touch the START/ESETpad to cancel the cycle. The STARTBESETlight will
flash while the water is pumped out if needed, This takes approximately 2 minutes.
PDW9700 and PDW9900 Series: Open the door slowly to prevent splash-out. Touch the
STARTBESETpad to cancel the cycle. If the STARTIRESETlight is flashing. close the door
unt~l the water pumps out (this takes approximately 2 minutes) and the light stops flashing.
When the light stops flashing, the dishwasher can be reprogrammed and restarted