GE PDW8900 Series Technical Service Manual page 11

Door
P c
PDW8900 Series
,
. .
PDW9700 Series and PDW9900 Series
Note:
For top control dishwashers, there must be
112-inch clearance between the
top of
the door and
the counter top.
The door panel covers the main control boord.
detergent cup, vent fan, motor, louver, wire harness,
Smart Dispense bottle. Smart Dispense detergent
sensor, Smart Dispense pump, and door-interlock
switch.
The outer door panel is held in place by 1 2 screws
(5 Phillips head screws per side and two1/0-in. hex
head screws at the bottom).
The door panel covers the main control board,
detergent cup, wire harness. Smart Dispense bottle.
Srnort Dispense detergent sensor, and Smort
Dispense pump.
Escutcheon
Keypad
Assembly Screws
n
switch
Note: A ribbon coble connects the keypad
membrane (3-digit display on some models1 to the
control circuit boord. Due t o the ribbon length, care
must be taken when removing the door panel to
ensure that the ribbon coble is not damaged.
The outer door panel is held in place by 12 screws
( 5 Phillips head screws per side and two '10-in. hex
. -
head screws at the bottom). The esutcheon keypad
is held on by 4 screws.
Note: When removing the outer door ponel, be
careful not to remove the 4 screws (2 per side1
holding the escutcheon t o the door assembly.
Remove these only to gain access to the control
module, active vent, flapper, and door interlock