Before You Begin; First-Time Power-On - Mitsubishi Electric 738 Series Owner's Manual

8
1. Basic Setup and Operation

Before You Begin

1.
Review the important safety, installation, and oper-
ating information at the beginning of this book.
2.
Choose a location for your TV.
• Allow at least four inches of space on all sides
of the TV to help prevent overheating. Over-
heating may cause premature failure of the TV
as well as shortened lamp life.
• Avoid locations where light may reflect off the
screen.
• See the stand requirements on
3.
Install the batteries in the remote control.
4.
Plug the TV into an AC power outlet.

First-Time Power-On

1.
TV
Press the
ensure that the remote
control is in TV mode.
2.
Aim the bulb end of the
remote control at the TV and
press the POWER key
for the Welcome screen.
3.
If you wish to change the
menu language to Español,
press .
4.
Press to highlight EXIT.
Press ENTER to clear the
menu.
Downloaded From TV-Manual.com Manuals
For assistance call 1(800) 332-2119
page 2.
key to
TV
TV
. Wait
TV Tips
Turning the TV On or Off
• Point the bulb end of the remote control at the
front of the TV and press the POWER key.
POWER button on the TV control
• Press the
panel.
If You Turn Off the TV by Mistake
POWER again, within about 60 seconds,
• Press
to have the TV come back on immediately.
STATUS indicator is flashing green, (about
• If the
60 seconds after you shut off power), wait a
few moments for the indicator to stop flashing
and press POWER to turn the TV on again.
Controlling Sound Volume
VOL to adjust the sound level.
• Press
• See also "Controlling A/V Receiver Sound
Volume" on page 31.
Changing Channels (antenna sources)
NOTE: Perform a channel scan to enable recep-
tion of digital channels. See Setup > Channel,
page 55.
• Enter the channel number using the number
keys on the remote control and press ENTER.
For a two-part digital channel, such as 3-1,
—
press 3 CANCEL 1 to include a dash (separator).
CH to change channels one channel at a
• Press
time.
CH to move quickly through
• Press and hold
channels.
• Press LAST to return to the previously tuned
channel.
• Press GUIDE to display ChannelView channel
listings, highlight a channel, and press ENTER.
• Use the Fav (Favorites) feature to tune to up to
nine favorite channels. See
CH key to tune to preselected groups
• Use the
of channels using ChannelView custom
channel banks. See page
page 28.
29.