53 Fba Data Out; Group 55 Communication Tool - ABB ACSM1 Manual

212
Group

53 FBA DATA OUT

These parameters select the data to be sent by the fieldbus controller to the drive,
and need to be set only if a fieldbus adapter module is installed. See also
A – Fieldbus control
Notes:
• This parameter group is presented in the User's Manual of the fieldbus adapter as
parameter group 2 or B.
• The new settings will take effect when the drive is powered up the next time
(before powering off the drive, wait at least 1 minute), or when parameter
FBA PAR REFRESH
• The maximum number of data words is protocol-dependent.
53
53.01 FBA DATA OUT1
Selects data to be transferred from the fieldbus controller to the drive.
0
1
2
3
11
12
13
1001...9999
53.02 FBA DATA OUT2
...
53.12 FBA DATA OUT12
See
Parameters and firmware blocks
on page 423.
is activated.
53.01 FBA DATA OUT1.
FW block: None
Not in use.
Control Word (16 bits).
Reference REF1 (16 bits).
Reference REF2 (16 bits).
Control Word (32 bits).
Reference REF1 (32 bits).
Reference REF2 (32 bits).
Parameter index.
FW block: None
FW block: None
Appendix
51.27