Group 17 Panel Display - ABB ACSM1 Manual

Group 17 PANEL DISPLAY
Selection of signals for panel display.
17
17.01 SIGNAL1 PARAM
Selects the first signal to be displayed on the control panel. The default signal is
Value pointer: Group and index
17.02 SIGNAL2 PARAM
Selects the second signal to be displayed on the control panel. The default signal is
Value pointer: Group and index
17.03 SIGNAL3 PARAM
Selects the third signal to be displayed on the control panel. The default signal is
Value pointer: Group and index
17.04 SIGNAL1 MODE
Defines the way the signal selected by parameter
optional control panel.
(-1) Disabled
(0) Normal
(1) Bar
(2) Drive name
(3) Drive type
17.05 SIGNAL2 MODE
Defines the way the signal selected by parameter
optional control panel.
(-1) Disabled
(0) Normal
(1) Bar
(2) Drive name
(3) Drive type
FW block: None
FW block: None
FW block: None
FW block: None
17.01 SIGNAL1 PARAM
Signal not displayed. Any other signals that are not disabled are
shown together with their respective signal name.
Shows the signal as a numerical value followed by unit.
Shows the signal as a horizontal bar.
Shows the drive name. (The drive name can be set using the
DriveStudio PC tool.)
Shows the drive type.
FW block: None
17.01 SIGNAL1 PARAM
Signal not displayed. Any other signals that are not disabled are
shown together with their respective signal name.
Shows the signal as a numerical value followed by unit.
Shows the signal as a horizontal bar.
Shows the drive name. (The drive name can be set using the
DriveStudio PC tool.)
Shows the drive type.
1.03 FREQUENCY.
1.04 CURRENT.
1.06 TORQUE.
is displayed on the
is displayed on the
Parameters and firmware blocks
143