Configuration Via Web Browser - Bosch NBN-80052 Installation Manual

30 en | Configuration
7.3

Configuration via web browser

The unit must have a valid IP address and a compatible subnet
mask to operate on your network. By default, DHCP is pre-set at
the factory to On and so your DHCP server assigns an IP
address. With no DHCP server the default address is
192.168.0.1
To view the camera in your web browser:
1.
2.
3.
Note:
To see live images in your browser it might be necessary to
download and install the MPEG-ActiveX from the Bosch
download store.
IP Helper tool
Alternatively, use the IP Helper tool to detect Bosch devices on
the network:
1.
2.
Protected network
If a RADIUS server is used for network access control (802.1x
authentication), the unit must be configured first. To configure
the unit, connect it directly to a computer using a network cable
and configure the two parameters, Identity and Password. Only
after these have been configured can communication with the
unit via the network occur.
2015.04 | v2.0 | AM18-Q0665
Start the Web browser.
Enter the IP address of the unit as the URL.
During initial installation, confirm any security questions
that appear.
Select a camera
Click Open in browser to view the camera interface.
DINION IP starlight 8000
Bosch Security Systems
MP