Table of Contents
Advertisement
A
DMINISTRATION OF THE
6.2
Input Parameter Byte 01
Parameter Byte 01 is shown on the top line with the currently set values.
B . 7 4 0 6
B Y T E
For the purposes of manipulation, the individual bits of the new byte are to be entered on the
second line using "0" and "1". The complete Parameter Byte must always be recorded and
confirmed with the ENT key.
The bits of the Parameter Byte are numbered in descending order:
Bit 7
0
1
Bit 6
0
1
Bit 5
0
1
Bit 4
0
1
Bit 3
Bit 2
Bit 1
Bit 0
6.2.1 Bit7/Bit4 - Slave Line 1/2 in 12 or 24 Hour Operation
For pole-changing pulse operation.
With this function, the two lines can control different clocks for pole-changing pulse operation
in 12 or 24 hour operation.
Analogue clocks usually 12 hour operation
Digital clocks usually 24 hour operation
Slave Line 1:
Bit 7 = 0
Bit 7 = 1
Slave Line 2:
Bit 4 = 0
Bit 4 = 1
7406RC Slave Clock Control Board for System 7001RC - V02.03
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: info@hopf.com
B
7406RC
OARD
N O . : 0 3
=
B I T
7 . . 0
Hour Mode Slave Line 1
12 hour operation
24 hour operation
Slave Lines (SL) 2 as minute or second lines
Minutes (SL1) + Seconds (SL2)
Minutes (SL1) + Minutes (SL2)
Summertime/ Wintertime changeover
Stop (1h)
Update display
Hour Mode Slave Line 2
12 hour operation
24 hour operation
No function at present
For compatibility reasons these bits should always be set to 0.
12 hour operation
24 hour operation
12 hour operation
24 hour operation
O L D :
B Y T E
0 1
N E W :
B Y T E
0 1
>
0 1 1 0 0 0 0 0
<
> ~ ~ ~ ~ ~ ~ ~ ~ <
17 / 27
Advertisement
Table of Contents
