Implementation Of The Board 7406Rc In The System 7001Rc; Identification Of The Board Numbers Available; Set The Board Number - hopf 7406RC Technical Manual

I
MPLEMENTATION OF THE
5 Implementation of the Board 7406RC in the
System 7001RC
All RC function boards are individually parameterized from the system 7001RC.
The following steps are necessary for implementation:


Identification of the board numbers available


Setting up of the board number with the DIP switch on the board 7406RC

Installation of the board 7406RC in the system 7001RC

Parameterization of the board 7406RC

Activation of the board 7406RC via the system 7001RC
5.1 Identification of the Board Numbers available
The board numbers allocated so far can be displayed via the SHOW ALL ADDED SYSTEM-
BOARDS menu. The board numbers that are not listed for this board type are available for
the new board.
5.2

Set the Board Number

In order to clearly identify the board in the system 7001RC, the board number must be
defined via the DS1 DIP switch bank. The board number is set as Hex code on DS1. Switch
8 is the lowest value bit and switch 1 the highest value bit. The inscription on the DIP switch
housing serves to identify switches 1-8. Board numbers from 1 to 31 can be setup, board
numbers outside this range are not recognized by the system 7001RC.
7406RC Slave Clock Control Board for System 7001RC - V02.03
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: info@hopf.com
B 7406RC S
OARD IN THE
Every RC function board is uniquely identified via the board type and an
assigned board number (1-31)
Boards that are available in terms of hardware, but which have not yet been
activated via the system menu, are not listed in the SHOW ALL ADDED
SYSTEM-BOARDS menu. (The "SEND" LED of these boards does not
flash when in operation.)
In order to identify the set board number, these boards must be made
available externally, in order to identify the set board number from the DIP
switch setting.
Under no circumstances may two boards of the same type with the same
board number be embedded in one system 7001RC. This leads to
undefined errors on both boards.
7001RC
YSTEM
13 / 27