Parametrize / Activating The Board 7406Rc In The System 7001Rc - hopf 7406RC Technical Manual

I
MPLEMENTATION OF THE
5.4 Parametrize / Activating the Board 7406RC in the
System 7001RC
The following steps are required to activate the board:

In the BOARD-SETUP menu, sub-heading ADD SYSTEM-BOARDS, log on the
newly installed board.

In the BOARD-SETUP menu, sub-heading SET SYSTEM BOARDS PARAMETER
parameterize the board. (Chapter 6 Administration of the Board 7406RC)

In the BOARD-SETUP menu, sub-heading SET SYSTEM BOARDS TO
MONITORING-MODE OR IDLE-MODE integrate the newly installed board into the
monitoring system.
7406RC Slave Clock Control Board for System 7001RC - V02.03
hopf
Elektronik GmbH
Nottebohmstr. 41 • D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: info@hopf.com
B 7406RC S
OARD IN THE
To avoid undesirable output behaviour of the board it is first parameterized
and then activated by switching it into the monitoring system.
The menus:

ADD SYSTEM-BOARDS and

SET SYSTEM BOARDS TO MONITORING-MODE OR IDLE-
MODE
can be consulted in the technical specification of the system 7001RC.
7001RC
YSTEM
15 / 27