Marani CLP-260 User Manual page 19

Note: for the all Dynamic Processes as the AGC, RMS Compressor and
Peak Limiter, it is necessary, in order to make them working properly, to
be in a condition similar to the one described before for the 0dBu path.
Any different condition on the Input Signal, can bring to the same output
results if the Input Level Potentiometer will be Adjusted in order to be
close to the Input Clipping condition, which means that if the Input Signal
will be lower/higher than 0dBu, the potentiometer will have to adjust the
input to the A/D converter so to go back to a "0dBu" condition as the one
used as reference.
A.G.C.:from this page it is possible to set the parameters of the Automatic
Gain Controller.
AGC Bypass: from this screen it is possible to set the AGC On or OFF, so
to activate it or not without resetting the all parameters; use the
"VARIATION" encoder for toggling the AGC Bypass On/Off.
The following is an example screen for the "AGC Bypass" page where the
AGC is set Active
Ch.A A.G.C.
< Bypass = ON >
AGC Exp Time:from this screen it is possible to set the AGC Expansion
time from 0.057 seconds up to 14.4 seconds; use the "VARIATION"
encoder to set the value.
The following is an example screen for the "AGC Exp time" page where
the Expansion Time is set to 1.5S
AGC Cmp Time: from this screen it is possible to set the AGC
Compression time from 0.014 seconds up to 6 seconds; use the
"VARIATION" encoder to set the value.
The following is an example screen for the "AGC Cmp time" page where
the Compression Time is set to 0.5S
18