Table of Contents
Advertisement
Getting Started
As soon as the CLP260 is turned ON the device model name will appear
in the LCD screen:
CLP260
Compressor Limiter
And after showing quickly the "Firmware Version 2.212", the LCD will
show the "Input Level Page, by default, where is possible see thanks to
graphic meters, the Input level
When the Input Level is in clipping, the symbol">" will appear (as for the
channel B in the example)
From this initial condition, and if an RMS Compressor or a Peak Limiter
(or both) are set to be active, their compression/limiting activity can be
seen thanks to a the "Compressor Activity" and "Limiter Activity" windows,
accessible from the Input Level one just rotating the NAVIGATION
encoder clock/counter-clock wise.
If in example from the Input level window the user want to see the RMS
Compressor's activity, it is enough to rotate the NAVIGATION Encoder
clockwise twice, so accessing the following screen:
Where the compression activity is shown from right to left, matching the
depth of the compression on the base of the Compression Coefficient
Value: if the coefficient is equal 1, then no compression is occurring and
no bars are displayed, if the coefficient is <1, then as more the coefficient
is far from 1 as more from right to left bars will appear.
F o r t h e r e l a t i o n b e t w e e n t h e b a r s i n t h e I n p u t L e v e l ,
Compression/Limiting Activity windows and the Input signal level and
compression depth, refer to the Appendix 1 tables.
11
Advertisement
Table of Contents
