Construction Characteristics; Package Contents; Accessories Supplied On Request; Application - Accorroni GHIBLI 4-5-6 ELITE Technical Information

Air heater operation is controlled by the built-in
room thermostat and by a digital timer that may
be supplied on request.

1.4 CONSTRUCTION CHARACTERISTICS

The casing is built with ivory-coloured, epoxy-
powder painted steel plate, with sides made with
black, heat-resistant nylon. The two air intake
and delivery grilles are located, respectively, at
the bottom and at the top of the casing.
The control panel is located on the front of the
appliance. This panel includes the following:
- on/off switch
- convection fan speed switch (models 5 and 6)
- reset switch for the burner control device
- lockout led
- heat request led
- room thermostat regulation dial
The rear of the appliance includes the following:
- the connector for the combustion air inlet and
combustion product exhaust ducts
- the holes to attach the appliance to the wall
- the entry with cable gland for the air heater
electric power supply
The following is installed inside the appliance:
- the combustion chamber and the finned heat
exchanger with flue gas exhaust fan located
after the heat exchanger.
- the atmospheric burner with ignition electrode
and flame detection electrode
- a tangential convection fan for Ghibli model 4
and a centrifugal type with double impeller and
central motor for Ghibli models 5 and 6
- the fan control
thermostat
- the electric board including the burner control
device, the gas unit, the room thermostat and
related wiring

1.5 PACKAGE CONTENTS

The air heater is shipped with cardboard packing
with two polystyrene foam protection shells which
also contain:
- the intake and exhaust duct for walls up to 40
cm, complete with connector flange, ceramic
fibre gasket, attachment screws and wind
protection terminal
- gas conversion kit with label.
- the gas on-off valve
- a screwdriver to disassemble the casing
- this installation and servicing technical
information manual as well as warranty
documents
thermostat and safety

1.6 ACCESSORIES SUPPLIED ON REQUEST

In addition to the material described above, the
following accessories can also be supplied on
request:
- intake and exhaust duct, 100 cm
- intake and exhaust doubling device including
terminals, to be used with separate ducts Ø 60
mm, rigid or bendable (see point 4.2.1)
- protection grille for standard terminal
- digital timer kit

1.7 APPLICATION

The Ghibli gas heater is an
appliance designed to heat individual rooms.
This design solution is a good alternative to
traditional equipment, since it does not involve
costly installation work and allows heat to be
managed in a personalised manner, room by
room, only when it is needed. The Ghibli gas
heater is ideal for single-family dwellings, vacation
homes, offices, stores, laboratories.
It is particularly suitable for restructuring projects,
where a traditional system would require major
masonry work or involve exorbitant costs. The
Ghibli gas heater can also be added to an
existing system.
WARNING! It is important to verify that the
design and installation conform with current
standards.
page 5
independent