Clutch Housing; Engine - Graco LineLazer 3400 Repair Manual

Removal
1. Remove clamp. Do Clamp Removal, page 10.
2. F . 11. Remove four screws (51) and lock washers (50)
IG
which hold clutch housing (45) to engine.
3. Remove screw (145) from under mounting plate.
4. Pull off clutch housing (45).
Installation
1. F . 11. Push on clutch housing (45).
IG
2. Install four capscrews (51) and lock washers (56) and
secure clutch housing (45) to engine. Torque to 200 in-lb
(22.6 N·m).
3. Install screw (145) from beneath mounting plate. Torque
to 26 ft-lb (35.2 N·m).
Removal
NOTE: All service to the engine must be performed by
an authorized HONDA dealer.
1. Remove Pinion Assembly/Clutch Armature/Clamp and
Clutch Housing, as instructed on pages 9, 10 and 11.
2. F . 12. Disconnect all necessary wiring.
IG
3. F . 13. Remove two locknuts (111) and screws (110)
IG
from base of engine.
4. Lift engine carefully and place on work bench.
pink
(from engine)
ground
green/yellow
F . 12
IG
311019L

Clutch Housing

51
F . 11
IG

Engine

clutch wires
F . 13
IG
Installation
1.
2.
ti6390a
3.
4.
5.
45
50
145
Lift engine carefully and place on cart.
F . 13. Install two screws (110) in base of engine and
IG
secure with locknuts (111). Torque to 20 ft-lb (27.12 N·m).
F . 12. Connect all necessary wiring.
IG
Install Pinion Assembly/Clutch Armature/Clamp and
Clutch Housing, as instructed on pages 9 and 10 and 11.
Set engine to 3300 rpm.
Clutch Housing
ti6322a
110
ti6323a
111
11