Clutch Housing - Graco EM 5000 Instructions-Parts List Manual

NOTE: A standard steering wheel puller is required to
remove the clamp. Two 1/4–28 x 3 or 4 in. long
screws are also needed.
NOTE: Refer to Fig. 30.
1. Loosen the two screws (16) on the clamp (3), work-
ing through the slot at the bottom of the clutch hous-
ing (2).
2. Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp (3). Tighten the screws
(C) until the clamp comes off.
3. Skip ahead to Reassembly, page 29, Step 3., or
continue to the right.
NOTE: Refer to Fig 31. The motor and clutch housing
were removed from the cart previously.
1. Remove the four capscrews (62) and lockwashers
(9) which hold the clutch housing (2) to the adapter
plate (48).
2. Remove the key (13).
3. Pull off the clutch housing (2).
4. Go to Reassembly,
page 29, Step 1..
Motor Capacitor and Inductor Coil
NOTE: A replacement capacitor may include a new re-
sistor, installed. The start capacitor (1b) and the
inductor coil (1c) are located under cover A. The
run capacitor (1d) is located under cover B.
NOTE: Refer to Fig. 32.
1. Remove the cover (A or B).
2. Remove the flag connectors from the old capacitor
or inductor coil.
3. Connect flag connectors of the new component.
4. Replace the cover.
Clamp
2
A
B
C
Fig. 30

Clutch Housing

48
74
47
2
9
62
Fig. 31
1
13
A
B
Fig. 32
3
16