Clutch Housing - Graco GM 1030 Instructions-Parts List Manual

Clamp
NOTE:
A Stan dard steerina
M
I
{heel puller and
two1/4-28 x 3 or 4 in. long screws are required to
remove the clamp.
NOTE:
Refer to Fig. 25.
1. Loosen the
two screws
(4)
on the clamp (1
5 ) .
working through the slot at the bottom of the clutch
housing (17).
2. Install two screws
(e)
of the tool (A) in two of the
threaded holes in the clamp. Tighten the screw (C)
until the clamp comes off.
3.
Go to
Reassembly,
page 26, Step 3, or continue
below.
Clutch
Housing
NOTE: Refer to Fig. 26.
1. Remove the capscrews (11) and lockwashers (12)
which hold the clutch housing (17) to the engine
(45).
2. Remove the engine key (14).
3.
Pull
off the clutch housing (17).
4. Go to
Reassembly,
page 26, Step
1
8 d
Fig. 26
308-269
25