Stopping; After Work Is Completed - Husqvarna PP 440 HF Operator's Manual

• On the saw unit WS 440 HF, the blade's rotation direction
is adjustable.
Press "arrow up" on the remote control unit's membrane
key to select the direction. The display shows "BLADE
ROTATION? STANDARD" or "BLADE ROTATION?
REVERSE". To change the current selection, press "OK".
This must only be done when the blade is not moving.
• Start the blade rotation by pushing and holding the green
start button while turning the control for rotation direction
clockwise. When the blade rotation has started, you can
release the start button. Turn the control to the desired
position. The number of revolutions is shown on the
display.
• For more information on blade rotation and suitable
blades for various revolution speeds, see table in technical
specifications.
• The water cooling starts automatically when the blade
starts to rotate. The water flow is adjusted with the ball
valve at the incoming water connector on the power unit.
• Start the blade motion by turning the blade motion knob
on the remote control in the desired direction.
• Start the saw unit's travel feed by turning the travel feed
control in the desired direction.
• Read through the manual supplied with the wall saw for
further instructions in sawing technique.
12 –
English
STARTING AND STOPPING

Stopping

• To switch off the blade rotation, turn the blade rotation
control anti-clockwise back to its zero position. Also turn
the depth feeding and travel feeding controls to their zero
positions.
• Turn the main switch on the power unit to "0"-position.

After work is completed

Dismantling the equipment
• Disconnect the incoming power lead and incoming water
hose.
• Disconnect the power lead and water hose between the
power unit and the saw unit.
• If there is a risk of freezing, the machine must be drained
of any remaining water coolant.
Cleaning
Make sure to keep the connectors and pins clean. Clean with
a rag or brush.
Do not use a high pressure washer to clean the power unit.