Table of Contents
Advertisement
Basic Shooting
Procedures
Preparations
2
4
POWER
3
ON
OFF
MODE
.
1 Supply battery or AC adapter power to the
camera recorder.
(A P22 [Power Supply] )
2 Insert an SD card.
(A P33 [SD Card] )
3 Turn on the power of the camera recorder.
Hold down the lock button (blue) at the center of
the [POWER ON/OFF] switch to set to "ON". The
camera recorder starts up in Camera mode and
is ready for recording.
4 Adjust the angle of the LCD monitor and
viewfinder.
(A P30 [Adjusting the LCD Monitor and
Viewfinder] )
Shooting
1 Configure the video and audio input
settings.
Set the [FULL AUTO ON/OFF] switch to "ON"
0
to enter Full Auto mode. This mode adjusts
the Iris, Gain, Shutter and White Balance
automatically.
The audio recording level is also set to Auto,
0
and audio from the built-in microphone is
recorded in the Full Auto mode.
The a icon appears at the lower center area
0
of the LCD in the Full Auto mode.
4030 20
10
0
P 13000K
.
4
1
00: 00: 00.00
Jan 12, 2016
12 :34 : 56
AE
6
+
Memo :
To set each individual video setting item
0
automatically or manually, and to carry out the
audio input settings and the audio recording
level adjustment, refer to the following.
[Adjusting the Brightness] (A P 48)
0
[Adjusting the Iris] (A P 48)
0
[Setting the Gain] (A P 49)
0
[Setting the Electronic Shutter] (A P 50)
0
[Adjusting the White Balance] (A P 51)
0
[Adjusting Audio Recording Level]
0
(A P 56)
2 Press the [REC] button to start recording to
the SD card.
This camera recorder has three [REC] buttons.
Any of the [REC] buttons can be used to start/
stop recording by default.
The tally lamp lights up in red during recording.
Zoom Operation
0
(A P41 [Zoom Operation] )
Adjusting the Focus
0
(A P43 [Focus Operation] )
Memo :
If both the slots are loaded with recordable cards
0
in the factory default, pressing the [REC] button
starts recording only to the media in the selected
slot.
When [Main Menu] B [System] B [Record Set]
B [Slot Mode] is set to "Dual", recording can be
performed simultaneously to the cards in both
the slots.
(A P66 [Dual Rec] )
The tally lamp can be turned off in [System] B
0
[Tally Lamp].
(A P102 [ Tally Lamp ] )
3 Check the most recently captured images.
Press the [C.REVIEW/7] button on the lens to
0
activate the Clip Review function. The most
recently captured images are played back on
the LCD monitor and viewfinder screen.
After playback, the camera recorder returns
0
to standby mode (STBY).
(A P64 [Viewing Recorded Videos
Immediately (Clip Review)] )
Memo :
[Clip Review] is assigned to [C.REVIEW/7]
0
button in factory default.
[Clip Review] can also be assigned to other user
0
buttons.
(A P32 [Assignment of Functions to User
Buttons] )
Basic Shooting Procedures
39
Advertisement
Table of Contents
