Instruction Manual - Siemens SMD21300 Instruction Manual

10.03
Main menu
Configuration
(S)
Info (U)
14
Function Adjustment/range Description
Backlight (S)
Backlight control On/off
Saved backlight 0-1023 (read only)
reference value
Actual backlight 0-1023
reference value
Backlight sensor 0-1023 (read only)
value
Temperature (S)
Current temperature Read only
Max. temperature Read only
over lifetime
LUT (S) - Selection list 1-5
- Linear
Status (U)
Type Read only
Serial number Read only
Hardware revision Read only
FPGA 1 revision Read only
FPGA 2 revision Read only
Firmware rev. Read only
Active LUT Read only
DPMS mode Read only
Display temp. Read only
Backlight working Read only
hours
Backlight control Read only
value
Backlight reference Read only
value
Backlight sensor Read only
value

Instruction Manual

Activation/deactivation of backlight control
Last saved reference value of backlight control
Current reference value of backlight control
Actual value of backlight. This is continuously
measured by the internal backlight sensor
Current temperature of display
Maximum temperature reached since delivery
Selection of a customer-specific LUT.
These are loadable using SMfit ACT version 3.0
or later.
None of the customer-specific LUTs is selected,
thus non-corrected display of gray scales.
Type of unit (e.g. SMD 21300)
Serial number of display
Release version of hardware
Release version of FPGA 1
Release version of FPGA 2
Release version of firmware
Number of currently selected LUT
On/off mode: with PLANON backlight, the lamp
is switched off when the video signal is
switched off
On/dimmed mode: with the CCFL, the lamp is
dimmed to 10% when the video signal is
switched off.
The computer's operating system is used for
timing and activating the DPMS.
Current temperature of display
Working hours of display since delivery
Control value for the backlight
Display of reference value of backlight control
Display of actual value of backlight control
21" gray scale flat panel display SMD 21300
A5E00185696B-001