Samson 3730-2 Mounting And Operating Instructions page 102

Code list
Diagnosis errors
Error codes – Recommended
action
79 Diagnostic messages Messages generated by the extended diagnostics
Status classification
80 Diagnostic
parameters
Status classification
Recommended action Confirm error. Check and, if necessary, perform a new reference test.
81 Reference graphs
Status classification
Recommended action Check and, if necessary, perform a new reference test.
102
Condensed state message active, when prompted, Err appears.
When fault alarms exist, they are displayed here.
Maintenance required (cannot be classified)
Error in parameters not critical to control operation.
Maintenance required (cannot be classified)
Error occurred during plotting the reference graphs for drive signal y
steady-state or drive signal y hysteresis.
• Reference test canceled
• Reference line for drive signal y steady-state or drive signal y hyster-
esis was not adopted.
Error messages are not yet saved in a non-volatile memory. They cannot
be reset.
[No message]
EB 8384-2 EN