Related Manuals for EINHELL BG-PW 48
Summary of Contents for EINHELL BG-PW 48
- Page 1 Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:33 Uhr Seite 1 Operating Instructions Petrol Water Pump BG-PW Art.-Nr.: 41.713.43 I.-Nr.: 11010...
- Page 2 Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:33 Uhr Seite 2 Read and follow the operating instructions and safety information before using for the first time.
- Page 3 Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:33 Uhr Seite 3...
- Page 4 Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:34 Uhr Seite 4...
- Page 5 Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:34 Uhr Seite 5...
-
Page 6: Table Of Contents
Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:34 Uhr Seite 12 Table of contents 1. Safety regulations 2. Layout 3. Intended use 4. Technical data 5. Before putting the equipment into operation 6. Operation 7. Cleaning, maintenance, storage and ordering of spare parts 8. Disposal and recycling 9. -
Page 7: Layout
Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:34 Uhr Seite 13 3. Proper use Important! When using equipment, a few safety precautions The machine is suitable for irrigating and watering must be observed to avoid injuries and damage. landscaped areas, vegetable beds and gardens and Please read the complete operating manual with due for operating lawn sprinklers. -
Page 8: Technical Data
Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:34 Uhr Seite 14 4. Technical data 5.2 Connecting and routing the intake and discharge lines Connect the intake line to the intake connection Engine type: 4-stroke engine; air-cooled (Figure 3 / Item 11) and the discharge line to the Max. -
Page 9: Cleaning, Maintenance, Storage And Ordering Of Spare Parts
Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:34 Uhr Seite 15 6.2 Intake process 7.2 Maintenance During the priming process, the shut-off devices In this connection, please also read the attached present in the pressure pipe (spray nozzles, service information valves etc.) must be completely open so that the air in the suction pipe can escape freely. -
Page 10: Disposal And Recycling
Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:34 Uhr Seite 16 7.3 Storage Rinse the pump thoroughly with water before lengthy periods of inactivity or winter storage. Close the petrol cock and allow the engine to run until it stops to empty the carburetor. Fill the tank fully to prevent rust formation. Remove the drain plug (Figure 3 / Item 12) and fully drain the pump housing. - Page 11 Anleitung_BG_PW_48_SPK1:_ 25.06.2008 9:34 Uhr Seite 17 9. Troubleshooting Fault Cause Remedy Engine does not start Spark plug fouled Clean or replace the spark plug Air filter dirty Clean the air filter. No fuel in the tank Top up fuel. Automatic oil cut-out has not re Check oil level, top up engine oil sponded Pump fails to prime...
- Page 12 Of course, we are also happy offer a chargeable repair service for any defects which are not covered by the scope of this guarantee or for units which are no longer covered. To take advantage of this service, please send the device to our service address. EINHELL AUSTRALIA PTY LTD 6/166 Wellington Street Collingwood VIC 3066...