Honda VFR 800 Owner's Manual page 67

Engine Oil Changing Engine Oil & Filter
a
6. Remove the oil filter with a filter wrench
and let the remaining oil drain out. Make
sure the prior seal is not stuck to the
engine.
Discard the oil and oil filter at an
a
approved recycling centre.
Rubber
seal
Oil filter
64
32MGY600.indb 64
7. Apply a thin coat of engine oil to the
rubber seal of a new oil filter.
8. Install a new oil filter and tighten.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft).
9. Replace the sealing washer. Install the
drain bolt and tighten.
Torque: 30 N·m (3.1 kgf·m, 22 lbf·ft).
10. Fill the crankcase with the recommended
oil ( ) and install the oil fill cap.
P.47
Required oil
When changing oil &
engine oil filter:
3.1 litres (3.3 US qt, 2.7 Imp qt)
When changing oil only:
2.9 litres (3.1 US qt, 2.6 Imp qt)
11. Check the oil level.
12. Check that there are no oil leaks.
P.61
2011/01/11 16:28:07