Audiovox Jensen CD3210 Owner's Manual page 3

CD3210
Preparation (continued)
Install Half-Sleeve
1. Install adapter if necessary (optional).
2. Install half-sleeve into adapter or dashboard.
3. Push tabs out to secure half-sleeve in the radio opening.
4. Install support strap to make unit more stable.
Set Frequency Spacing Switch
There is a selectable frequency spacing switch on the bottom of the unit. Before installing the
unit into the dashboard, confirm that the switch is set to the correct setting for your area of
operation [US 10KHz/200KHz, European 9KHz/50KHz].
Wiring
Wiring with a Wiring Adapter (Purchased Separately)
Connect Wires
You can make all these connections without even being in the car.
1. Splice or crimp wires.
2. Attach wiring adapter to car wiring harness.
Wiring Diagram / Color Codes
1. RCA-to-RCA cables (not supplied)
2. Amplifier wiring (see amplifier instructions)
3. Power Antenna (dark blue wire) - Connect to power antenna or amplifier. If not used, tape
bare end of wire.
4. Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis.
5. Memory/Battery (yellow wire) - Connect to battery or 12 volt power source that is always
alive. The radio will not work if this wire is not connected.
6. Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse.
7. Left front speaker
8. Right front speaker
9. Left rear speaker
10. Right rear speaker
Fuses
When replacing a fuse, make sure the new fuse is the correct type and amperage. Using an
incorrect fuse could damage radio. The CD3210 uses one 10 amp fuse located below the
wiring connector: 10 amp fast blow ATO.
Reconnect Battery
When wiring is complete, reconnect the battery negative terminal.
Install Half-Sleeve
Instalación de la Camisa
Installation du demi-manchon
3
2
Wiring
Cableado
Câblage
White/Black (-)
Blanco/Negro (-)
Blanc/Noir (-)
7
White / Blanco / Blanc (+)
Green/Black (-) Violet/Black (-)
Verde/Negro (-) Violeta/Negro (-)
Vert/Noir (-)
9
Green / Verde / Vert (+)
Violet / Violeta / Violet (+)
3
Connect Wires
Conecte los cables
Raccordement des fils
4
1
10A
2
1
Red / Roja / Rouge
AMP
White / Blanco / Blanc
3
4
+
5
6
Gray/Black (-)
Gris / Negro (-)
Gris / Noir (-)
8
Gray / Gris / Gris (+)
Violet/Noir (-)
10
Jensen Connector
1
2