Bfd Mad-Enabled Irf Configuration Example For A Two-Chassis Irf Fabric - HP 12500 SERIES Configuration Manual

BFD MAD-enabled IRF configuration example for a
two-chassis IRF fabric
Network requirements
Set up an IRF fabric at the distribution layer of the network in
IRF fabric and set up BFD MAD links between the member devices. Disable the spanning tree
feature on the ports used for BFD MAD, because the two features conflict with each other.
Assign the highest member priority to Device A so it can be elected the master.
Figure 17 Network diagram
Configuration procedure
Configure Device A:
1.
# Assign member ID 1 to Device A and bind Ten-GigabitEthernet 3/0/1 to IRF-port 2.
<Sysname> system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the member reboots and operates in IRF
mode.
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
[Sysname] irf-port 2
[Sysname-irf-port2] port group interface ten-gigabitethernet 3/0/1
[Sysname-irf-port2] quit
[Sysname] interface ten-gigabitethernet 3/0/1
[Sysname-Ten-GigabitEthernet3/0/1] undo shutdown
[Sysname-Ten-GigabitEthernet3/0/1] quit
Figure
42
17. Configure BFD MAD in the