Nikon KEYMISSION 360 Reference Manual page 90

Pairing the Camera and Remote Control
Before using the remote control for the first time, it must be paired with the camera.
* In this manual, "pairing" refers to the establishment of a Bluetooth connection between
the camera and remote control.
The camera can only be paired with one remote control at a time. When the
camera is paired to a different remote control, only the most recent pairing
information is saved.
1
Launch the SnapBridge 360/170 app on your smart device, and
tap c Camera M Remote options M Pair remote.
When the status lamps on the camera flash green at the same time for a while and
then alternately flash green, the camera enters pairing standby mode for the
remote control.
If pairing fails, the status lamps on the camera flash red six times at the same time,
and then turn off. Turn off the camera, and then press and hold the movie button
on the camera for about 7 seconds. The camera turns on in pairing standby mode
for the remote control. Proceed to step 2.
2
Check that the remote control is off, and then press and hold (for
at least 3 seconds) the power button on the remote control.
Pairing starts for the camera and remote control. While the process is being
performed, the status lamp on the remote control flashes green.
When pairing is complete, the status lamp on the remote control turns off, and the
status lamps on the camera flash green twice at the same time.
If pairing fails, the status lamps on the camera flash red six times at the same time.
Perform the procedure again from step 1.
Technical Notes
Accessories
70