Default Settings - Moultrie M-80BLX Instructions Manual

B
PLOTSTALKER ACTIVITY SEARCH
ACTIVITY SEARCH
The Search Feature will scan through your photos and automatically
look for changes in regions that you identify in Setup.
In search mode, the PlotStalker software scans through the .mlt photo file, stops
on a photo when changes are found in your identified region, and then highlights
the changes in blue. You can click anywhere in the video viewing area to remove
the blue highlights.
ACTIVITY SEARCH SETUP
Click the Settings button to activate
the Region and Sensitivity settings
for the Activity Search
DEFINE SEARCH REGION
Provides the ability to search for
changes in the photo in a specific
region rather than the entire photo.
Click on the Set Motion Search Area Button.
1
Use the mouse to select and drag the red outline around the area you want to
2
search for movement. This allows you to focus on a very precise area if
required.
Click OK button on the Settings Popup window to confirm your settings and
3
exit the menu.
SENSITIVITY
Set to High, Medium or Low - This sets the level of pixel change the program
1
will detect. Note; a pixel change will occur with a color, intensity, lighting or
movement so this setting is critical to obtain the desired results.

DEFAULT SETTINGS

Click on Default button to return to the default values for Search Area and
1
Sensitivity settings
Page 14
PlotStalker Software
Slide the UNLOCK switch on the bottom of Camera and use the knob to pull
the slide-out Battery Tray. Install four(4) or eight(8) AA size alkaline or
lithium batteries with polarities as indicated in the Battery Tray. Re-install the
Battery Tray.
Thread the provided Mounting Strap through the Eyelets on the back of the
camera and secure to a tree or pole approximately 36" from the ground as
shown.
Turn Camera on by sliding ON/OFF/AIM switch to
the ON position.
Press the MODE button one time to get to the
Camera Setup Menu. Set Time and Date by pressing
ENTER, using UP/DOWN to adjust selected field,
LEFT/RIGHT to move to the next field and ENTER
when done.
Press MODE button until MENU SELECTION
screen is displayed. Use the UP/DOWN buttons
until the MAIN SCREEN option is highlighted
yellow. Press ENTER.
Your Camera will now automatically take pictures
whenever an animal is detected in range -based on
the default settings below.
Capture Mode
Photo Quality
Photo Delay after each photo is taken
Multi Shot Count
Digital Zoom
Video Resolution
Video Length
Video Audio
Camera Name
Temperature
Info Strip printed on photos
Plot Frequency
Plot Duration
Default Setting
Delete All?
M-80BLX GameSpy Digital Camera
Eyelet
Mounting
Strap
TRAIL CAM (Still)
HIGH
1 MIN
OFF
NO ZOOM
HIGH
5 SEC
ON
MYCAMERA
Fahrenheit
ON
15 SECONDS
3 HOUR
NO
NO
Page 3