Table of Contents
Advertisement
B
PLOTSTALKER ACTIVITY SEARCH
ACTIVITY SEARCH
The Search Feature will scan through your photos and automatically
look for changes in regions that you identify in Setup.
In search mode, the PlotStalker software scans through the .mlt photo file, stops
on a photo when changes are found in your identified region, and then highlights
the changes in blue. You can click anywhere in the video viewing area to remove
the blue highlights.
ACTIVITY SEARCH SETUP
Click the Settings button to activate
the Region and Sensitivity settings
for the Activity Search
Moultrie Products, LLC
DEFINE SEARCH REGION
FCC Statements
MCG-12592
Provides the ability to search for
changes in the photo in a specific
Note: Changes and modifications not expressly approved by the party responsible could void the user's authority to operate this device.
region rather than the entire photo.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
Click on the Set Motion Search Area Button.
1
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
NOTE: This device complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy
Use the mouse to select and drag the red outline around the area you want to
2
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
search for movement. This allows you to focus on a very precise area if
guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
required.
following measures:
- Reorient or relocate the receiving antenna.
Click OK button on the Settings Popup window to confirm your settings and
3
- lncrease the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
exit the menu.
- Consult the dealer or an experienced radio/TV technician for help.
SENSITIVITY
Set to High, Medium or Low - This sets the level of pixel change the program
1
will detect. Note; a pixel change will occur with a color, intensity, lighting or
movement so this setting is critical to obtain the desired results.
DEFAULT SETTINGS
Click on Default button to return to the default values for Search Area and
1
Sensitivity settings.
GPS Latitude - 000.000000 N
GPS Longitude - 000.000000 W
Page 18
D-555i Digital Game Camera
Page 14
PlotStalker Software
II
QUICK START INSTRUCTIONS
STEP 1
Press the PUSH BUTTON RELEASE on the bottom of Camera and use the knob to pull the
slide-out Battery Tray. Install six (6) C-cell alkaline batteries with polarities as indicated in
Slide the UNLOCK switch on the bottom of Camera and use the knob to pull the
the Battery Tray. Re-install the Battery Tray and insert your SD card.
slide-out Battery Tray. Install or eight(8) AA size alkaline or lithium batteries
STEP 2
Thread the provided Mounting Strap through the Eyelets on the back of the camera and
with polarities as indicated in the Battery Tray. Re-install the Battery Tray.
secure to a tree or pole approximately 36" from the ground as shown.
Thread the provided Mounting Strap through the Eyelets on the back of the
STEP 3
Turn Camera on by sliding IR AIM/OFF/ON switch to the ON position.
camera and secure to a tree or pole approximately 36" from the ground as shown.
STEP 4
Press the MENU button to enter the main menu, press up and
Turn Camera on by sliding ON/OFF/IR TEST switch
OK to select camera setup. Press OK to enter General setup.
to the ON position.
Set Time and Date by pressing OK, using UP/DOWN to adjust
selected field, LEFT/RIGHT to move to the next field and OK
Press the MODE button one time to get to the
when done.
Camera Setup Menu. Set Time and Date by pressing
ENTER, using UP/DOWN to adjust selected field,
STEP 5
Press MENU button to return to main menu screen.
LEFT/RIGHT to move to the next field and ENTER
Press DOWN and OK to select CAPTURE MODE.
when done.
STEP 6
Switch camera to IR Aim. Aim camera using motion
Press MODE button until MENU SELECTION
detection to determine target area. Walk in front of the
screen is displayed. Use the UP/DOWN buttons
camera at the desired distance and the camera LED will
until the MAIN SCREEN option is highlighted
flash showing the covered area.
yellow. Press ENTER.
STEP 7
Switch camera to ON. Your camera will now automatically
Your Camera will now automatically take pictures
take pictures whenever an animal is detected in range,
whenever an animal is detected in range -based on
based on the default settings below.
the default settings below.
III
Capture Mode
DEFAULT SETTINGS
Photo Quality
Photo Delay after each photo is taken
Motion Freeze
General
Motion Detect
Multi Shot Count
DATE/TIME:
01/01/99 12:00am
EVENT DELAY:
Video Resolution
ERASE IMAGES:
PHOTO OR VIDEO:
NO
Video Length
CAPTURE MODE:
Video Audio
MOTION DETECT
PHOTO QUALITY:
Camera Name
IR FLASH:
AUTO
MULTI-SHOTS:
Temperature
GEOTAGGING:
OFF
MOTION FREEZE:
Info Strip printed on photos
CAMERA NAME:
MOULTRIECAM
VIDEO LENGTH:
Plot Frequency
TEMPERATURE:
FAHRENHEIT
Plot Duration
GPS Longitude & Latitude:
Default Setting
Delete All?
Security Code
D-555i Digital Game Camera
M-880 GameSpy Digital Camera
Eyelet
Mounting
Strap
TRAIL CAM (Still)
2.0 MP
5 SEC
ON
Time Lapse
OFF
10 SECONDS
INTERVAL:
10 SECONDS
VGA
MULTI PROGRAM:
PHOTO
2 PROGRAM
5 SEC
HIGH (4 MP)
ON
PROGRAM 1 WAKE UP:
6 AM
MOULTRIECAM
OFF
PROGRAM 1 SLEEP:
9 AM
FAHRENHEIT
ON
PROGRAM 2 WAKE UP:
4 PM
ON
10 SECONDS
PROGRAM 2 SLEEP:
7 PM
15 SECONDS
PHOTO QUALITY:
HIGH (4 MP)
3 HOUR
000.000000 N / 000.000000 W
NO
NO
00000
Page 3
Page 3
Hide quick links:
Advertisement
Table of Contents
