Removing The Speaker Module - Acer Aspire 4810 Series Disassembly Instruction

12. Disconnect the touchpad cable from the touchpad board; then carefully pry loose and remove the touch
pad board
WARNING:The touchpad board is glued to the upper case, only remove the touchpad board if it is defective.
Note: Circuit board > 10cm
above. Please detach the circuit board and follow the local regulations for disposal.

Removing the Speaker Module

1. See "Removing the Battery Pack" on page 5.
2. See "Removing the Lower Cover" on page 6.
3. See "Removing the Lower Cover" on page 6.
4. See "Removing the Optical Drive Module" on page 7.
5. See "Removing the DIMM" on page 7.
6. See "Removing the Hard Disk Drive Module" on page 8.
7. See "Removing the SSD Module" on page 9.
8. See "Removing the RTC Battery" on page 9.
9. See "Removing the Keyboard" on page 12.
10. See "Removing the WLAN Board Module" on page 13.
11. See "Separating the Upper Case from the Lower Case" on page 14.
18
2
has been highlighted with the red rectangle as shown in the figure