York XP SERIES W/SIMPLICITY Installation Manual page 52

5168273-YIM-A-1115
1034349-UCL-C-0315
Unit inspected for shipping, storage, or rigging damage
Unit installed with proper clearances
Unit installed within slope limitations
Refrigeration system checked for gross leaks (presence of oil)
Terminal screws and wiring connections checked for tightness
Filters installed correctly and clean
Economizer hoods installed in operating position
Condensate drain trapped properly, refer to Installation Manual
Economizer damper linkage tight
Gas Heat vent hood installed
All field wiring (power and control) complete
Alignment of drive components
Belt tension adjusted properly
Blower pulleys tight on shaft, bearing set screws tight, wheel tight to shaft
Pressure switch or transducer tubing installed properly
Exhaust Inspection
Check hub for tightness
Check fan blade for clearance
Check for proper rotation
Check for proper mounting (screen faces towards unit)
Prove operation by increasing minimum setting on economizer
Economizer Inspection Standard
CO sensor installed
2
Check economizer setting (Reference SSE Control Board LCD menu location)
Prove economizer open/close through SSE Board Setting
Humidity Sensor (2SH0401) _____________________________________________
Unitary Products Group
52
General Inspection
Air Moving Inspection
Powered Barometric Relief
Yes No
Reheat Mode Normal
REFERENCE
BAS
or Alternate Not Applicable
Completed See Notes
Completed See Notes
Completed See Notes
Completed See Notes
Johnson Controls Unitary Products
3