Table of Contents
Advertisement
Message
Supplied Buffer was too small
for amount of data.
Ultra returned Negative
response.
Unknown Command
Unknown Drive Letter
Unknown Error (Error = xxx).
7-26 Programmer's Manual
Solution
Call Technical Support at the phone
number on the back of this manual.
The printer timed out before it could
complete the command. Increase
the length of the timeout with the
settimeout command and retry the
command that timed out.
Verify the spelling of the command
name and re-enter it.
Retry the udiskfree command, but
c
specify either
letter.
A UServe error occurred. Physically
reboot the printer (not with the
reboot command), start UServe, and
try the command again. If the error
still occurs, have the printer
serviced.
d
or
as the drive
Advertisement
Table of Contents
