Paxar 9855 Operator's Handbook Manual page 31

6. Adjust the supply holder guides so the sides barely touch the
roll. Make sure the supply roll turns freely.
7. Push down on the supply lever to unlock the supply guides.
The supply guides have been angled slightly for string tag
supplies.
8. Lay the supply across the supply guide so that a few inches
extend past the front of the printer. Tuck the supply under the
nibs and in between the die cut sensor.
9. Adjust the supply guides so they touch the supply. Push up
on the supply lever to lock the supply guides into place.
Die Cut
Sensor
Nib
Supply Lever
Loading Supplies 2-15