Menu Level 1: Set Temperature - Waeco CoolAir SP 950T Installation Manual

Installation
7.3.2

Menu level 1: Set temperature

The unit always starts with a defined value for the room temperature. This
parameter can be configured between 17 and 30 °C (62 and 86 °F).
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 35).
✓ The first digit of the display (fig. 8 5,page 6) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the Operating Mode button (fig. 8 4,page 6) to change the
parameters.
➤ Use the + and – buttons (fig. 8 6 and 7, page 6) to select the target
value (in °C) at which the unit should start operation.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Press the Operating Mode button (fig. 8 4,page 6) to confirm your
entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 1 again and can use the + and – buttons to
switch between menu levels.
36
CoolAir SP950T
EN