Xerox Phaser 3121 Manual page 108

Problem
Background
scatter
Misformed
characters
Page skew
Curl or wave
Background scatter results from bits of toner distributed on
the printed page.
• The paper may be too damp. Try printing with a different
batch of paper. Do not open packages of paper until
necessary so that the paper does not absorb too much
moisture.
• If background scatter occurs on an envelope, change the
printing layout to avoid printing over areas that have
overlapping seams on the reverse side. Printing on seams
can cause problems.
• If background scatter covers the entire surface area of a
printed page, adjust the print resolution through your
software application or the printer properties.
• If characters are improperly formed and producing hollow
images, the paper stock may be too slick. Try a different
paper. See "Paper Specifications" on page 7.13.
• If characters are improperly formed and producing a wavy
effect, the scanner unit may need service. Verify that it
also occurs on a demo page by pressing the
on the control panel when the printer is ready. For service,
contact a service representative.
• Check the paper type and quality. See "Paper
Specifications" on page 7.13.
• Ensure that the paper or other material is loaded correctly
and the guides are not too tight or too loose against the
paper stack.
• Check the paper type and quality. Both high temperature
and humidity can cause paper curl. See "Paper
Specifications" on page 7.13.
• Turn over the stack of paper in the input tray. Also try
rotating the paper 180° in the input tray.
• Push the output lever and try printing to the face up
output slot.
Solution
S
OLVING
button
6
P 6.15
ROBLEMS