Leveling Your Washer; Complete Installation - Kenmore 59229212 Owner's Manual And Installation Instructions

Leveling your washer

See if the washer is level by checking the position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour the water into the tub to
just below the pulsator level.
Loosen
Adjustable legs
3. If the washer is level, the pulsator is positioned at the
center of the water as shown in the figure. If not, level
your washer by turning the front leveling feet clockwise or
counterclockwise as necessary.
Turn the front leveling feet clockwise to raise the washer, and
counterclockwise to lower the washer.
Kenmore OEM washer_592-29212_DC68-03133J-02_EN.indd 11
Pulsator
Lock

Complete Installation

1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method.
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Dispose of or recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet .
Do not remove ground prong .
Do not use an adapter .
Do not use an extension cord .
Failure to follow these instructions can result in death,
fire, or electrical shock .
7 . Plug into a grounded 3 prong outlet.
8. Read "Washer Use."
9. To test and to clean your washer, using only "HE" High
Efficiency detergent, measure ½ the amount of detergent
recommended by the manufacture for a medium size load.
Pour the detergent into the detergent dispenser. Select
NORMAL/CASUAL, and then select START. Allow the washer
to complete one whole cycle.
Use only HE High Efficiency detergent.
11
2015/12/16 18:41:26